1994 international 9400 with N14
Trying to figure out a problem with my ignition. the truck will not crank at all, unless I use a toggle switch I made to start it. the toggle is tapped into the BAT terminal and IGN on the switch harness. starts every time when I use the toggle. I was told to run an additional 12 gauge power wire from the BAT wire on the switch harness to a a constant 12v (I chose my magnetic switch relay behind the dash). this didn’t change anything. also tried a new ignition switch with no change.
I used a volt meter to measure OHMS from the BAT to IGN on the actual switch (with switch removed from truck) and everything checks out with key on and cranking. any ideas?
Leave a Reply